Overview
Exhaust Gas Temperature Monitor, Type STM-RW-2 (601540)
- Rod length expansion
- Microswitch
- Automatic reset
- Breakage protection
- DIN reg. no. ATW 862
Panel-Mounted Thermostat EM Series up to 500 °C (602021)
- Liquid expansion
- Self-monitoring
- Safety switch-off
- 1, 2, 3, or 4 single-pole snap-action switches possible
JUMO heatTHERM – Panel-Mounted Thermostat (602031)
- Liquid expansion
- Microswitch with snap-action system
- Temperature compensation
- Safety switch-off
- Cadmium-free, RoHS compliant
JUMO heatTHERM P100 – panel-mounted thermostat
- Temperature controller (TR)
- Entry-level class thermostat
- Simple and quick installation
- Low space requirement
Surface-Mounted Single Thermostats, ATH Series (603021)
- Sturdy case (protection type IP54)
- Microswitch
- Self-monitoring (STB/STW)
- Safety switch-off (STB/STW)
- Tested according to DIN EN 14597
Surface-Mounted Double Thermostat, ATH Series (603026)
- Liquid expansion
- Microswitch
- Self-monitoring (STB/STW)
- Safety switch-off (STB/STW)
- 2 separate measuring and switching systems
Surface-Mounted Single or Double Thermostat, ATH-SW Series (603035)
- Liquid expansion
- Microswitch
- One or two separate measuring and switching systems
- Protection type: IP65
JUMO heatTHERM-AT and JUMO heatTHERM-DR (603070) – Surface-Mounted Thermostat
- Liquid expansion
- Microswitch with snap-action system
- Temperature compensation
- "Push-In®" clamps
- UL approval possible
Surface-Mounted Thermostats, AMTHF Series (603051)
- Liquid expansion
- Microswitch with snap-action switch system
- 2, 3, or 4 single-pole switching steps
JUMO frostTHERM-AT/-DR (604100)
- "Push-In" connection technology
- Max. switching capacity 16 A, 230 V
- Protection type (AT) IP40 - IP65
(DR) IP20
JUMO frostTHERM-ATE (604170)
- Setting range +1 to +10 °C
- Operating mode: manual or automatic reset
- Membrane heating for operation up to -15 °C
- Self-monitoring of the probe line
- Two analog outputs 0 to 10 V
- One switching output (relay: max. AC 230 V 6(2) A)
- Can be set without opening the case lid
- Electrical connection via tension spring terminals
- Operating voltage (SELV) AC 24 V
Hot air thermostats, model WTHc (60.4514)
- Fluid expansion
- Micro switch
- 3 separate measuring and switching systems
- Sturdy case
JUMO exTHERM-AT (605055) – Explosion-Protected Surface-Mounted Thermostat
- Can be directly applied in zones 1 and 2 or 21 and 22
- Switching capacity 16 A as standard, optionally 25 A
- Admissible ambient temperature: -60 to +70 °C
- Thermowell for zone 0 available as an accessory
- Single thermostat and double thermostat
Contact dial thermometer (60.8425)
- Capillary measuring system
- Any installation position
- Round version with stainless steel housing
- Class 1
MICROSTAT-M (60.8501)
- Capillary measuring system
- Temperature controller
- Plastic housing (standard)
- Suitable for panel-mounting
Contact dial thermometer (60.8520)
- Capillary measuring system
- Stainless steel case for panel-mounting/add-on devices
- Anti-kink spring
- Suitable for panel-mounting
Contact dial thermometer (60.8523)
- Capillary measuring system
- Stainless steel case with bayonet connection
- Panel-mounting/add-on device
- Anti-kink spring
- Protection class IP65
Contact dial thermometer (60.8540)
- Capillary measuring system
- UV-stabilized polyamide case
- Optionally with fly back
Hygrostat (Hygrometric) (907032)
For easy two-state control of relative air humidity
- For indoor and duct versions
- Also available with covered setpoint adjuster
- Duct version can be used continuously in areas of high humidity
- Indoor version also suitable for flush-mounted box installation
- With potential-free changeover contact(s)
- No voltage supply required (passive operation)
- Sensing element is maintenance-free when operated in a clean environment